COMPARATIVE STUDY ON ENHANCING THE MECHANICAL PROPERTIES OF CLAYEY SAND WITH WASTE PLASTIC FIBERS AND LIME

Hadj Bekki, Abdelhakim Guezzoul, Tefaha Cherrak, Rachid Boumeddiene, Hadj Benhebal

Abstract


Introduction. The stabilization of clayey soils remains a dynamic and evolving field, with ongoing research exploring new materials, techniques, and sustainable practices to address the challenges posed by problematic soils in construction and infrastructure development. The aim of the study is to investigate the improvement of compaction and mechanical properties of clayey sand by reinforcing its structure with polyvinyl chloride (PVC) plastic fibers of varying sizes and proportions, and/or by applying lime treatment at a minimal dosage. Methods. The different mixtures were evaluated through a series of tests, including Proctor compaction tests, California Bearing Ratio (CBR) tests, and direct shear tests conducted under unconsolidated undrained conditions, to assess their mechanical behavior and strength enhancements. Results indicated that larger PVC fibers yielded the highest CBR values, even surpassing those achieved through lime treatment alone. Furthermore, the CBR index of the soil increased proportionally with the amount of PVC fibers added. It was also observed that the short-term behavior of clayey sand is significantly improved when reinforced with plastic fibers, whether used independently or in combination with lime treatment. This improvement can be attributed to the combined effects of lime, which strengthens the soil by reducing plasticity and increasing cohesion, and the structural contribution of larger plastic fibers, which promote better interlocking and reinforcement. These findings suggest that stabilizing clayey soils using PVC waste fibers and/or minimal lime treatment offers a technically effective and economically viable solution, while also supporting sustainable development goals.

Keywords


clayey sand; stabilization; PVC plastic waste; lime; mechanical properties

Full Text:

PDF

References


AFNOR Editions (1992). NF P11-300. Earthworks. Classification of materials for use in the construction of embankments and capping layers of road infrastructures. Paris: AFNOR Editions, 21 p.

AFNOR Editions (1994). NF P94-071-1. Soil investigation and testing. Direct shear test with shearbox apparatus. Part 1: direct shear. Paris: AFNOR Editions, 16 p.

Afrin, H. (2017). A review on different types soil stabilization techniques. International Journal of Transportation Engineering and Technology, Vol. 3, Issue 2, pp. 19–24. DOI: 10.11648/j.ijtet.20170302.12.

Amakye S. Y. and Abbey S. J. (2021). Understanding the performance of expansive subgrade materials treated with nontraditional stabilisers: a review. Cleaner Engineering and Technology, Vol. 4, 100159. DOI: 10.1016/j.clet.2021.100159.

Amena, S.(2022). Utilizing solid plastic wastes in subgrade pavement layers to reduce plastic environmental pollution. Cleaner Engineering and Technology, Vol. 7, 100438. DOI: 10.1016/j.clet.2022.100438.

Arora, A., Singh, B., and Kaur, P. (2019). Performance of nano-particles in stabilization of soil: a comprehensive review. Materials Today: Proceedings, Vol. 17, Part 1, pp. 124–130. DOI: 10.1016/j.matpr.2019.06.409.

ASTM International (2021). ASTM D1883-21. Standard test method for CBR (California Bearing Ratio) of laboratorycompacted soils. West Conshohocken, PA: ASTM International, 8 p.

ASTM International (2012). ASTM D-698. Standard test methods for laboratory compaction characteristics of soil using standard effort (12,400 ft-lbf/ft3 (600 kN-m/m3)). West Conshohocken, PA: ASTM International, 13 p.

ASTM International (2019). ASTM D6276-19. Standard test method for using pH to estimate the soil-lime proportion requirement for soil stabilization. West Conshohocken, PA: ASTM International, 5 p.

Ayub, F. and Khan, S. A. (2023). An overview of geopolymer composites for stabilization of soft soils. Construction and Building Materials, Vol. 404, 133195. DOI: 10.1016/j.conbuildmat.2023.133195.

Behnood, A. (2018). Soil and clay stabilization with calcium- and non-calcium-based additives: a state-of-the-art review of challenges, approaches and techniques. Transportation Geotechnics, Vol. 17, Part A, pp. 14–32. DOI: 10.1016/j.trgeo.2018.08.002.

Bekkouche, S. R., Benzerara, M., Zada, U., Muhammad, G., and Ali, Z. (2022). Use of eco-friendly materials in the stabilization of expansive soils. Buildings, Vol. 12, Issue 10, 1770. DOI: 10.3390/buildings12101770.

Berrahou F. and Bendjilali L. (2023). Amélioration des propriétés géotechniques des argiles par ajout de déches plastiques. Master Thesis, Civil Engineering Department, University Ibn Khaldoun of Tiaret, Algeria.

Fondjo, A. A. and Theron, E. (2021). Expansive soils treatment using alternative methods: a comprehensive review. Civil Engineering and Architecture, Vol. 9, Issue 5, pp. 1295 – 1308. DOI: 10.13189/cea.2021.090503.

Gupta, G., Sood, H., and Gupta, P. K. (2024). Economic and environmental assessment of industrial wastes stabilized clay and sand soil subgrades using experimental and theoretical approaches. Construction and Building Materials, Vol. 422, 135787. DOI: 10.1016/j.conbuildmat.2024.135787.

LCPC & SETRA (2000). Réalisation des remblais et des couches de forme. Guide de Terrassement Routier GTR, Fascicule 1, LCPC & SETRA, France, pp. 35-95.

Liu, L., Cai, G., Zhang, J., Liu, X., and Liu, K. (2020). Evaluation of engineering properties and environmental effect of recycled waste tire-sand/soil in geotechnical engineering: a compressive review. Renewable and Sustainable Energy Reviews, Vol. 126, 109831. DOI: 10.1016/j.rser.2020.109831.

Maitlo, G., Ali, I., Maitlo, H. A., Ali, S., Unar, I. N., Ahmad, M. B., Bhutto, D. K., Karmani, R. K., Naich, S. R., Sajjad, R. U., Ali, S. and Afridi, M. N. (2022). Plastic waste recycling, applications, and future prospects for a sustainable environment. Sustainability, Vol. 14, Issue 18, 11637. DOI: 10.3390/su141811637.

Meddah, A., Goufi, A. E., and Pantelidis, L. (2022). Improving very high plastic clays with the combined effect of sand, lime, and polypropylene fibers. Applied Sciences, Vol. 12, Issue 19, 9924. DOI: 10.3390/app12199924.

Mishra, P., Shukla, S., and Mittal, A. (2022). Stabilization of subgrade with expansive soil using agricultural and industrial byproducts: a review. Materials Today: Proceedings, Vol. 65, Part 2, pp. 1418–1424. DOI: 10.1016/j.matpr.2022.04.397.

Nujid, M., Tholibon, D. A., and Kushairi Rahman, M. H. (2022). Effect of cockle shell powder as sustainable additive on geotechnical engineering properties of stabilized soil. Arabian Journal of Geosciences, Vol. 15, Issue 14, 1306. DOI: 10.1007/s12517-022-10593-6.

Suthar, L., Meena, S., and Kumar, U. (2024). Utilization of plastic waste in reinforcing sandy soil for sustainable engineering applications. Journal of Engineering Sciences, Vol. 11, Issue 1, pp. H1–H8. DOI: 10.21272/jes.2024.11(1).h1.

Thandabani, M. and Letcham, K. (2023). Experimental study on stabilization of black cotton soil with lime, plastic waste & red mud. International Journal of Engineering Research & Technology (IJERT), Vol. 12, Issue 09, IJERTV12IS090075. DOI: 10.17577/IJERTV12IS090075.

Zulkernain, N. H., Gani, P., Chuck Chuan, N., and Uvarajan, T. (2021). Utilisation of plastic waste as aggregate in construction materials: a review. Construction and Building Materials, Vol. 296, 123669. DOI: 10.1016/j.conbuildmat.2021.123669.


Refbacks

  • There are currently no refbacks.




     

ISSN: 2500-0055